Prototyping board for Digilent S6/S7/A7 CMOD FPGA modules, Arduino Nano & Every

<p>Prototyping board for use with Digilent's S6, S7 or A7 CMOD FPGA modules and Arduino Nano/Every boards (no modules or boards included, the ones shown are just examples).</p> <p>Features:</p> <p>· Works with any board that has 0.6" spacing with up to 48 pins:</p> <p>o Compatible with Digilent’s S6, S7 and A7 FPGA modules</p> <p>o Fully isolated DIP socket to allow use with many different boards (GND and VCC/VDD from your particular board will need to be jumpered to the protoboard's GND and V+)</p> <p>o Compatible with Arduino Nano and Every boards</p> <p>·</p> <p>· ENIG plated holes</p> <p>· 2 holes per pin for accessing FPGA PIOs and VU (CMOD GND is also board GND)</p> <p>o Can be used for making electrical connections to the prototyping area or</p> <p>o Connections to test equipment such as an oscilloscope, logic/protocol analyzer, other boards</p> <p>· 2 prototyping areas, one on each side of the board</p> <p>o Each side has:</p> <p>§ 4 columns with 35 rows of 3-hole nets</p> <p>§ 5 columns of V+ and GND rails in between and outside the 3-hole nets</p> <p>§ 20 10uF surface mount bypass capacitors at each end of the V+/GND rails (10V, 0805 footprint)</p> <p>§ Room for a pair of 400 tie-point breadboards (not included) like the ones shown (roughly 84mm x 54mm)</p> <p>· 7 GND test points, useful for oscilloscope or DMM probe grounding</p> <p>· 1 red test point for supplying V+ (labelled Vext) to the board (3.3V recommended for CMOD I/O compatibility)</p> <p>· 10uF surface mount bulk capacitor on V+/GND</p> <p>2-pin male header for supplying VCC from the PMOD (or other) connector, if desired, instead of the test points (but not both at the same time)</p> <p>3-pin male jumper for selecting the source for the V+ rails. Select either VCC from the 2-pin header from the PMOD connector (or other power pin depending on the board that is installed) or the red Vext test point</p> <p>· 4 holes in the corners for M3 standoffs, connected to the GND plane</p>

• Prototyping board for Digilent S6/S7/A7 CMOD FPGA modules, Arduino Nano & Every
• Prototyping board for Digilent S6/S7/A7 CMOD FPGA modules, Arduino Nano & Every
• Prototyping board for Digilent S6/S7/A7 CMOD FPGA modules, Arduino Nano & Every
• Prototyping board for Digilent S6/S7/A7 CMOD FPGA modules, Arduino Nano & Every
• Prototyping board for Digilent S6/S7/A7 CMOD FPGA modules, Arduino Nano & Every